[. . . ] *Note : You can verify that you have selected the correct code by pressing the [POWER] button. STEP4 Store the three-digit code by pressing the same [DEVICE] button once again. The device LED will blink twice to confirm that the code has been stored. [. . . ] STEP3 Point the remote control toward the TV and enter the three-digit code for your TV from the TV codes table. The device LED will blink twice to confirm that the code has been stored. 4 E. The Learning Method STEP1 Press the [COMPONENT] button (CBL, TV or DVD) to be programmed and the [INPUT] buttons simultaneously for 3 seconds until the Component LED light turns on. STEP2 Line up the UR3L-SR4 to the other remote, head-tohead, 1 or 2 inches apart. STEP3 Press any button on the UR3L-SR4 that you want to teach a command to. For example, if you want to teach the [MUTE] button, press the [MUTE] button. STEP4 Press and hold the [MUTE] button on the other remote until the UR3L-SR4 Component LED light blinks twice. *Note : The LED will blink 5 times if there was an error in the learning process. STEP5 Once you have completed teaching UR3L-SR4 all desired commands for that Component, save the learned commands by pressing the [COMPONENT] and [INPUT] buttons simultaneously until the Component LED blinks 3 times. Erasing a Single Learned Command STEP1 Press the [COMPONENT] and [INPUT] buttons simultaneously for 3 seconds until the Component LED light turns on. STEP3 To exit, press and hold both the [COMPONENT] and [INPUT] buttons simultaneously until the Component LED blinks 3 times. 5 G. Erasing All Lear ned Commands fr om One Component STEP1 Press the [COMPONENT] and [INPUT] buttons simultaneously for 3 seconds until the Component LED light turns on. STEP2 Press and hold both the [COMPONENT] button you want to erase and the [PAUSE] button for 5 seconds. STEP3 To exit, press and hold both the [COMPONENT] and [INPUT] buttons simultaneously until the Component LED blinks 3 times. H. Programming the All Off Button This allows you to program the All Off button so it can send up to three power On/Off commands with one button press. STEP2 Press the [All OFF] button and the [OK/SEL] button simultaneously for 3 seconds. STEP3 Press the first [COMPONENT] button you want to store in the [ALL OFF] button and then the [POWER] button. Repeat this for other Components until you have stored all the desired power commands into the [ALL OFF] button. [. . . ] Assigning the Volume and Mute keys to a Different Device CBL : TV TV : TV DVD : TV STEP1 Press the [OK/SEL] button and [CBL] button simultaneously for three seconds. STEP3 Press the [CBL] button corresponding to the device that you would like the volume and mute buttons to control. Example : If you wish to have the volume and mute keys operate your TV, press the [TV] button in Step3. K. [. . . ]